1990 115 VRO Installation

[Bruce]

1990 Evinrude 115 HP, model # E115TLESB

VRO SCHEMATIC LOCATION
Evinrude Parts 1990 E115TLESB 1990 VRO2 PUMP - 90-100-115 MODELS Diagram

During removal of the existing VRO pump, I discovered that the FUEL MANIFOLD ***EMBLY had separated at the top (inlet from fuel pump). When reviewing the VRO schematic diagram for my model engine (see VRO SCHEMATIC location above), I noticed that there were only two discharge nipples, located near the bottom of the manifold. The manifold that I am attempting to replace has three discharge nipples, one near the top and two near the bottom. The inlet nipple on the old manifold faces vertically, and the three discharge nipples all face the same direction, on the same axis. I also noted in the Evinrude service manual, 90 degree cross V models 85-115, 150-175, section 2, page 37, that the fuel manifold ***embly is configured like the one I need to replace.

Does anyone have any ideas on how to replace this manifold with the correct
***embly?

[boats.net]

The older 115 had one like you are talking about, look at Evinrude Parts 1985 E115TLCOS 1985 VRO PUMP Diagram