Buy Evinrude Outboard Parts

Announcement

Collapse
No announcement yet.

1992 Evinrude V4 140 HP

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 1992 Evinrude V4 140 HP

    I have a 92 Evinrude V4 140 HP on Ranger B*** boat and the motor runs great except for when im reading to take off out the hole shot, when i trim the motor all the way down..its runs very rough and then once i gun the throttle it takes 2-3 seconds for it really to get going. once it plains out it then runs fine again and idling with trim up runs fine. any thoughts?

  • #2
    Are the exhaust relief holes on back of mid section going under water?
    Regards
    Boats.net
    Evinrude Outboard Parts

    Comment


    • #3
      I don't believe so, no. I would have to check again, but if they were, how would that be fixed? And would that solve the problem?

      Comment


      • #4
        Then the motor is sitting too low in water, raise motor if possible or redistribute weight in boat so dont sit so low in water.
        Regards
        Boats.net
        Evinrude Outboard Parts

        Comment


        • #5
          there is hardly any weight in the boat besides the boat itself and the motor...how would i go about raising the motor? and if i can't what other options do i have

          Comment


          • #6
            How much would it need to raised to get ex holes out of water?, Is the anti-ventalation plate on gearcase even with bottom of hull or below it?
            Regards
            Boats.net
            Evinrude Outboard Parts

            Comment


            • #7
              what exactly do you mean by that. i'm not familiar with those terms. could anything else be causing this besides the setup of the motor?

              Comment


              • #8
                Put boat in water, Mark the water line on boat and take it to your local dealer and ask the for suggestions
                Regards
                Boats.net
                Evinrude Outboard Parts

                Comment

                Working...
                X