Buy Evinrude Outboard Parts

Announcement

Collapse
No announcement yet.

1991 tracker 25 HP fuel/air mixture screw

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 1991 tracker 25 HP fuel/air mixture screw

    does anyone know the correct amount of turns to set the fuel air mixture screw? thanks

  • #2
    Normally..............

    (Carburetor Adjustment - Single S/S Adjustable Needle Valve)
    (J. Reeves)

    Initial setting is: Slow speed = seat gently, then open 1-1/2 turns.

    Start engine and set the rpms to where it just stays running. In segments of 1/8 turns, start to turn the S/S needle valve in. Wait a few seconds for the engine to respond. As you turn the valve in, the rpms will increase. Lower the rpms again to where the engine will just stay running.

    Eventually you'll hit the point where the engine wants to die out or it will spit back (sounds like a mild backfire). At that point, back out the valve 1/4 turn. Within that 1/4 turn, you'll find the smoothest slow speed setting.

    When you have finished the above adjustment, you will have no reason to move them again unless the carburetor fouls/gums up from sitting, in which case you would be required to remove, clean, and rebuild the carburetor anyway.

    Comment

    Working...
    X