Tweet
hi all i have a 1985 15hp johnson that im rebuilding the carb for. i recieved the kit which had a white threaded plastic cone shaped sleeve ,nut ,bearing ,washer that i think goes with the low speed jet needle. could someone please explain the placement and install procedure for this " needle bearing" ? thanks
-
-
Answered in detail in the Johnson forum. -
thanks joe but
thanks for the reply Joe . I posted this question after doing an extensive search on the johnson website. i got a lot of results but none of them addressed the white plastic cone shaped threaded bearing for the low speed needle jet . it came in the omc rebuild kit and im sure it is used somewhere. i posted here in the evinrude forum because i thought they were similar to the johnson and somebody over here might know. im sorry if i offended anyone thanksComment
-
Thanks Joe
i went to the johnson site after i visited the evinrude site and thank you very much for reply. my email only alerted me of the evinrude forum reply and not
your reply at the johnson . thanks again just thought i would clear up your confusion about my confusionComment
-
No problem on my part as I frequent both those sites daily. However, as in the other forum... it just dawned on me that you state that bushing/bearing is threaded?? I never saw one threaded! Can you insert a picture of it?Originally posted by mixerman0915 View Posti went to the johnson site after i visited the evinrude site and thank you very much for reply. my email only alerted me of the evinrude forum reply and not
your reply at the johnson . thanks again just thought i would clear up your confusion about my confusionComment
-
pics
sorry about the blurry pic the piece is so small and my cam doesnt do very good at close up the threads are in the inside. i think i see threads anyways . thanks again for ur helpComment
Comment