Tweet
OK, I have determined that two of the six little recirculation valves on the manifold, just behind each carb, are bad. I cannot 'suck' any air or fuel out of them. They are blocked both directions. (These are the little nipple check valves that attach with small hoses to a nipple on the cylinder block to drain excess fluid from manifold area.)
The question is how do I get them out to clean/replace?
Heat, force, twist, pull....?????
Of course they are on the port side and the hardest to get access to.
Thanks
The question is how do I get them out to clean/replace?
Heat, force, twist, pull....?????
Of course they are on the port side and the hardest to get access to.
Thanks