If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Starts fine if i don't push the key in to engage choke. If I press the key in without start position the choke engages. When I push the key in to start position, nothing.
Any help greatly appreciated.
Arnie
Starts fine if i don't push the key in to engage choke. If I press the key in without start position the choke engages. When I push the key in to start position, nothing.
Any help greatly appreciated.
Arnie
If it's not cranking engine over when engaging choke then probably a bad ignition switch, if engine is cranking but wont start then may have a bad choke primer on engine.
Had the switch all disconnected & ohm meter checked OK. The choke primer works fine if I don't try to start. This is something that just happened all at once. I could take the switch out again & recheck again. Any other possibilities ?
Thank you for your response,
Arnie
Comment